Mass Air Flow (MAF) Circuit Low Input
How does a P0102 code trigger the check engine light? The engine light will come on if the following concern is present:
The Mass Air Flow Sensor circuit is monitored by the powertrain control module (computer), for low voltage (which translates to low air flow) through the Comprehensive Component Monitor (CCM). With the key on and engine running, if the voltage drops below a minimum value this code will be set, causing the check engine light to illuminate.
MAF Sensor disconnected
MAF Sensor circuit open to computer
Vehicle Power circuit open to MAF Sensor
Power Ground circuit open to MAF Sensor
MAF Sensor Return circuit open to PCM
MAF Sensor circuit shorted to Ground
Intake air leak near MAF Sensor
Damaged MAF Sensor
Refer to an appropriate manual for specification. If MAF Sensor voltage reading is below minimum limit with key on engine running then concern is a hard fault (present now). If all values are in spec proceed with intermittent diagnosis (refer to our “Intermittent Diagnosis Help” article through the “articles” link on the Navigation Bar). You may also use the “Get Help” link if you need specifications or have any other related questions.
Intake Cam Position Actuator Open Circuit – Bank 2
How does a P0020 code trigger the check engine light? This code will trigger the check engine light under the following condition:
The comprehensive component monitor, referred to as the CCM, monitors the Variable Camshaft Timing (VCT) circuit to the computer for high and low voltages. If the voltage falls below a set limit for a specific amount of time during this test, the check engine light will come on and set this trouble code.
Open or short in the VCT circuit
Open in the Vehicle Power circuit
Open or short in the VCT solenoid valve itself
Damaged computer (PCM)
This check engine light code is caused by a circuit fault of the VCT system. Testing should include all related wiring circuits, the VCT solenoid and PCM itself. Please refer to out article on Automotive Circuit Testing for help with this. You may also use the “Get Help” link if you need specifications or have any other related questions. Remember to refer to an appropriate manual for specific instructions.